** DISCONTINUED **
Please note, the chosen part is discontinued and therefore most likely not available for purchase!
(You won't be able to add it to your cart)
However, if this item is still in stock at CBS Racing, you will be able to buy it!
- If you see the "ADD TO CART" button we may have this item in stock, please try to add it to your cart.
- If you can not add it to your cart, we no longer have any left and we will remove the "ADD TO CART" button shortly.
Note: If the part you are looking for is discontinued, don't hesitate to contact us!
There might be a replacement part available or we may be able to find a Used or Second-Hand part for you.
-----------------------------------------------------------
Nissan Injector Seats, Top Feed Conversion Fuel Rail
These are the same machined aluminum injector seats used in Radium fuel rail kits. They are required when converting an OEM side feed injector to a top feed injector that uses a 14mm lower O-ring. They simply "pop" into the intake manifold (1 required per injector). They seal to the machined injector counterbore using the included Viton O-ring. The 2 sizes are based on the intake manifold's inside diameter of each injector counterbore. Below are just a few examples of some popular Nissan engines.
- 30mm = KA24DE S13/S14, SR20DET S13
- 25mm = RB25DET, SR20DET S14/S15, SR20VE FWD
All 30mm injector seats are bright-dipped black anodized. All 25mm injector seats are bright-dipped green anodized. The injector seats are CNC machined with a common 14mm bore for the lower injector O-ring.
Features
-CNC machined 6061 aluminum
-Bright dipped anodized
-Laser etched logo
-Viton O-rings
Installation
Thoroughly clean out any dirt or debris found in the intake manifold injector seat bores. Next, lubricate the Radium injector seat O-rings with engine oil. Press the Radium injector seats down firmly into the intake manifold injector ports until fully seated. If necessary, use a small rubber mallet.
