Electronics & Wiring
Check out our range of: engine control units, boost controllers, digital dash displays, gauges, ABS and traction control, power management, ignition, switches, relays, wiring and harness building, electrical tools, waterpumps, ecu harnesses adapters and connectors.
Wheelspeed To Can Module - ECUMaster
The Wheel Speed To CAN device is designed to measure frequency-type signals from 4 separate sensors and send that data over CAN BUS.
CAN Switchboard - ECUMaster
A CAN switchboard is a tiny device to allow easy transfer of up to 8 switch states and 8 analog signals over the CAN bus. In addition to this, the device has 4 built-in low side outputs that can be activated with a CAN bus message. The main purpose of this board is to build custom steering wheel panels containing buttons, rotary switches, and indicators.
Haldex Drag Controller - ECUMaster
Haldex Drag Racing Controller is an essential device for every competitor using a car equipped with a Haldex 4Motion system in drag racing.
DBW Module - ECUMaster
DBW Module is used to operate the electronic throttle device of the EMU
Connector Set EMU - ECUMaster
The connectors are there to install easily and quickly the EMU.
EDL-1 Datalogger - ECUMaster
THE DATALOGGER for EMU CLASSIC and EMU BLACK is capable of recording all log channels (the same as on PC) with 25Hz on SDHC card (4GB or bigger required)
Points to note with our logger is that it is capable of recording 11 hours data per 1GB.
8X EGT CAN BUS Module - ECUMaster
With this module, it is possible to connect 8 exhaust gas temperature sensors with Can Bus with the Ecumaster EMU.
This module is connected true the Can Bus communication port.
Bluetooth CAN BUS Module - ECUMaster
Wireless communication module to connect with mobile phones to ECU MASTER EMU.
With this Bluetooth module, it's possible to connect your mobile or tablet device to the ECU MASTER EMU.
Only compatible with Android.
This module is connected true the Can Bus communication port.
