Produkter tagget med 'link engine management'

CANLTW - CAN Connection Cable for G4X/G4+ WireIn ECU’s (6 Pin CAN)

CANTEE - Link CAN Splitter Cable

2 meter CAN Extension Cable for increased reach between your ECU CAN cable and CAN splitter/s or CAN device/s.

Deutsch DTM4 Connector Kit (Male) to create your own looms. 
DTM4 Male housing. Includes wedgelock and sockets.

Deutsch DTM4 Connector Kit (Female) to suit Link CAN Bus connections. Use to connect CAN devices into Link CAN bus. 
Includes Female Housing (Receptacle), Wedgelock & Pins

The Link CAN Gauge is a compact OLED gauge for displaying real-time data from your Link ECU’s CAN stream. Supported parameters such as boost pressure, air/fuel ratio, coolant temperature, fuel pressure, ethanol content, etc. can be displayed.

The 5 Bar MAP Variohm Eurosensor reads up to 4 Bar absolute pressure.

The 8 Bar MAP Variohm Eurosensor reads up to 7 Bar absolute pressure.

Inlet Air Temp Sensor 1/8 BSPT

Weld in Aluminium boss, 1/8" NPT Thread. Suitable for mounting Intake air temperature (IAT1-8), Coolant Temperature sensors (NTC1-8) and other sensors that use 1/8" NPT Thread.

Weld in steel boss, 1/8" NPT Thread. Suitable for mounting Intake air temperature (IAT1-8), Coolant Temperature sensors (NTC1-8) and other sensors that use 1/8" NPT Thread.

Includes Plug Kit - 2 way Bosch Style plug, terminals and boot

Aluminium and steel weld in mounting bosses available (IATBMA & IATBMS)